GENERAL CATALOGUE 2026.01

Modular units B series

Drain exhausts

Manual exhaust

Filter, filter-regulators, oil mist separators and active carbon filters cups need to drain the condense that accumulate during operations. Therefore cups are equipped with a drain exhaust which can be manual or automatic. With manual drain exhaust, condense is drained by the operator pushing a button located under the cup.

Push to drain

Condense drain

With automatic drain exhaust, however, condense is drained directly from the device when it reaches a pre-set level.

Automatic exhaust

Condense drain

Regulation knobs

Regulators and filter-regulators are equipped with plastic regulation knobs, with finger grip, which allows for practical, comfortable and accurate adjustment. Knob are also equipped with a locking system allowing to avoid involuntary adjustments, and the unlock position is highlighted by a red indicator strip. For regulate the flow unlock the knob pulling it up, rotate it clockwise to increase pressure or rotate it counterclockwise to reduce pressure. When the desired pressure value is reached, push the knob down to lock it.

Pressure reduction

Unlock

Pressure increase

Regulation knob

Lock

Pressure-gauges and pressure-switches Regulators, filter-regulators and soft-start valves are equipped with integrated analog square pressure-gauges, recessed into the component body, making it compact and with reduced overall dimensions. Furthermore on these modular units are also available version with a special female threaded adapter for mounting round analogic pressure gauges, or version with integrated digital pressure- switches (circuit PNP or NPN) mounted.

3 - AIR TREATMENT

Lubricant regulation

Lubricator are equipped with an oil filling system and an oil dripping regulation screw. Lubricant adjustment require to manually rotate the regulation screw until the desired oil flow is reached. To increase the lubricant flow turn counterclokwise the regulation screw. To reduce the lubricant flow turn clockwise the regulation screw. The oil flow sight glass, fully transparent, allow the oil dripping check. If lubricant refilling should be required, this can be done through the filler hole. To refill lubricant, remove the oil filler plug. When the desired lubricant level has been reached, replace the oil filler plug.

Oil flow increase

Oil flow reduction

Regulation screw

Oil flow sight glass

Oil filler plug

Allen key is required to remove and reinstall the oil filler plug. Lubricant can also be added without interrupting the air supply.

WARNING: Before any other maintenance operation, ensure that air supply and any electrical power supply are cut off, to avoid injury and damage to the product during disassembly and reinstallation.

Oil level inspection

3.4.13